Cisco WS-C3560E-24PD-E User Manual

B-12
Catalyst 3560 Switch Command Reference
78-16405-05
Appendix B Catalyst 3560 Switch Debug Commands
debug ilpower
debug ilpower
Use the debug ilpower privileged EXEC command to enable debugging of the power controller and
Power over Ethernet (PoE) system. Use the no form of this command to disable debugging.
debug ilpower {cdp | controller | event | ha | port | powerman | registries}
no debug ilpower {cdp | controller | event | ha | port | powerman | registries}
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines This command is supported only on PoE-capable switches.
When you enable debugging, it is enabled only on the switch.
Related Commands
cdp Display PoE Cisco Discovery Protocol (CDP) debug messages.
controller Display PoE controller debug messages.
event Display PoE event debug messages.
ha Display PoE high-availability messages.
port Display PoE port manager debug messages.
powerman Display PoE power management debug messages.
registries Display PoE registries debug messages.
Release Modification
12.1(19)EA1 This command was introduced.
12.2(25)SE The cdp, ha, and powerman keywords were added.
Command Description
show controllers power inline Displays the values in the registers of the specified PoE controller.
show power inline Displays the power status for the specified PoE port or for all PoE
ports.

Cisco WS-C3560E-24PD-E Specifications

General

Brand	Cisco
Model	WS-C3560E-24PD-E
Category	Switch
Language	English