2-390
Catalyst 3560 Switch Command Reference
78-16405-05
Chapter 2 Catalyst 3560 Switch Cisco IOS Commands
show errdisable detect
show errdisable detect
Use the show errdisable detect user EXEC command to display error-disabled detection status.
show errdisable detect [ | {begin | exclude | include} expression]
Syntax Description
Command Modes User EXEC
Command History
Usage Guidelines A displayed
gbic-invalid error reason refers to an invalid small form-factor pluggable (SFP) module.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
are not displayed, but the lines that contain Output are displayed.
Examples This is an example of output from the show errdisable detect command:
Switch> show errdisable detect
ErrDisable Reason Detection status
----------------- ----------------
udld Enabled
bpduguard Enabled
security-violatio Enabled
channel-misconfig Enabled
psecure-violation Enabled
vmps Enabled
loopback Enabled
pagp-flap Enabled
dtp-flap Enabled
l2ptguard Enabled
link-flap Enabled
gbic-invalid Enabled
dhcp-rate-limit Enabled
unicast-flood Enabled
storm-control Enabled
ilpower Enabled
arp-inspection Enabled
Note Though visible in the output, the ilpower, storm-control, and unicast-flood fields are not valid.
| begin (Optional) Display begins with the line that matches the expression.
| exclude (Optional) Display excludes lines that match the expression.
| include (Optional) Display includes lines that match the specified expression.
expression Expression in the output to use as a reference point.
Release Modification
12.1(19)EA1 This command was introduced.
To Next Page
Loading...
Need help?
General