Cisco WS-C3560E-24PD-E User Manual

2-375
Catalyst 3560 Switch Command Reference
78-16405-05
Chapter 2 Catalyst 3560 Switch Cisco IOS Commands
show controllers power inline
show controllers power inline
Use the show controllers power inline user EXEC command to display the values in the registers of the
specified Power over Ethernet (PoE) controller.
show controllers power inline [instance] [ | {begin | exclude | include} expression]
Syntax Description
Command Modes User EXEC
Command History
Usage Guidelines For the Catalyst 3560-48PS switches, the instance range is 0 to 11.
For the Catalyst 3560-24PS switches, the instance range is 0 to 5.
For the Catalyst 3560G-48PS switches, the instance range is 0 to 2. For instances other than 0 to 2, the
switches provides no output.
For the Catalyst 3560G-24PS switches, the instance range is 0 to 1. For instances other than 0 to 1, the
switches provides no output.
Though visible on all switches, this command is valid only for PoE switches. It provides no information
for switches that do not support PoE.
The output provides information that might be useful for Cisco technical support representatives
troubleshooting the switch.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
instance (Optional) Power controller instance, where each instance corresponds to four
ports. See the “Usage Guidelines” section for more information. If no instance is
specified, information for all instances appear.
| begin (Optional) Display begins with the line that matches the expression.
| exclude (Optional) Display excludes lines that match the expression.
| include (Optional) Display includes lines that match the specified expression.
expression Expression in the output to use as a reference point.
Release Modification
12.1(19)EA1 This command was introduced.

Cisco WS-C3560E-24PD-E Specifications

General

Brand	Cisco
Model	WS-C3560E-24PD-E
Category	Switch
Language	English