B-20
Catalyst 3560 Switch Command Reference
78-16405-05
Appendix B Catalyst 3560 Switch Debug Commands
debug lacp
debug lacp
Use the debug lacp privileged EXEC command to enable debugging of Link Aggregation Control
Protocol (LACP) activity. Use the no form of this command to disable debugging.
debug lacp [all | event | fsm | misc | packet]
no debug lacp [all | event | fsm | misc | packet]
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug lacp command is the same as the no debug lacp command.
Related Commands
all (Optional) Display all LACP debug messages.
event (Optional) Display LACP event debug messages.
fsm (Optional) Display LACP finite state-machine debug messages.
misc (Optional) Display miscellaneous LACP debug messages.
packet (Optional) Display LACP packet debug messages.
Release Modification
12.1(19)EA1 This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled. For
syntax information, select Cisco IOS Release 12.2 Configuration Guides
and Command References > Cisco IOS Configuration Fundamentals
Configuration Guide, Release 12.2 > System Management >
Troubleshooting and Fault Management.
show lacp Displays LACP channel-group information.
To Next Page
Loading...
Need help?
General