2-448
Catalyst 3560 Switch Command Reference
78-16405-05
Chapter 2 Catalyst 3560 Switch Cisco IOS Commands
show ipv6 mld snooping querier
show ipv6 mld snooping querier
Use the show ipv6 mld snooping querier user EXEC command to display IP version 6 (IPv6) Multicast
Listener Discovery (MLD) snooping querier-related information most recently received by the switch or
the VLAN.
show ipv6 mld snooping querier [vlan vlan-id] [detail] [ | {begin | exclude | include} expression]
Note This command is available only if the switch is running the advanced IP services image and you have
configured a dual IPv4 and IPv6 Switch Database Management (SDM) template on the switch.
Syntax Description
Command Modes User EXEC
Command History
Usage Guidelines Use the show ipv6 mld snooping querier command to display the MLD version and IPv6 address of a
detected device that sends MLD query messages, which is also called a querier. A subnet can have
multiple multicast routers but has only one MLD querier. The querier can be a Layer 3 switch.
The show ipv6 mld snooping querier command output also shows the VLAN and interface on which
the querier was detected. If the querier is the switch, the output shows the Port field as Router. If the
querier is a router, the output shows the port number on which the querier is learned in the Port field.
The output of the show ipv6 mld snoop querier vlan command displays the information received in
response to a query message from an external or internal querier. It does not display user-configured
VLAN values, such as the snooping robustness variable on the particular VLAN. This querier
information is used only on the MASQ message that is sent by the switch. It does not override the
user-configured robustness variable that is used for aging out a member that does not respond to query
messages.
VLAN numbers 1002 through 1005 are reserved for Token Ring and FDDI VLANs and cannot be used
in MLD snooping.
To configure the dual IPv4 and IPv6 template, enter the sdm prefer dual-ipv4-and-ipv6 {default | vlan)
global configuration command and reload the switch.
vlan vlan-id (Optional) Specify a VLAN; the range is 1 to 1001 and 1006 to 4094.
detail (Optional) Display MLD snooping detailed querier information for the
switch or for the VLAN.
| begin (Optional) Display begins with the line that matches the expression.
| exclude (Optional) Display excludes lines that match the expression.
| include (Optional) Display includes lines that match the specified expression.
expression Expression in the output to use as a reference point.
Release Modification
12.2(25)SED This command was introduced.
To Next Page
Loading...
Need help?
General