Cisco WS-C3560E-24PD-E User Manual

CHAPTER
1-1
Catalyst 3560 Switch Command Reference
78-16405-05
1
Using the Command-Line Interface
The Catalyst 3560 switch is supported by Cisco IOS software. This chapter describes how to use the
switch command-line interface (CLI) to configure software features.
For a complete description of the commands that support these features, see Chapter 2, “Catalyst 3560
Switch Cisco IOS Commands.” For information on the boot loader commands, see Appendix A,
“Catalyst 3560 Switch Boot Loader Commands.” For information on the debug commands, see
Appendix B, “Catalyst 3560 Switch Debug Commands.” For information on the show platform
commands, see Appendix C, “Catalyst 3560 Switch Show Platform Commands.” For more information
on Cisco IOS Release 12.2, see the Cisco IOS Release 12.2 Command Summary.
For task-oriented configuration steps, see the software configuration guide for this release.
In this document, IP refers to IP version 4 (IPv4) unless there is a specific reference to IP version 6
(IPv6).
CLI Command Modes
This section describes the CLI command mode structure. Command modes support specific Cisco IOS
commands. For example, the interface interface-id command only works when entered in global
configuration mode.
These are the main command modes for the switch:
• User EXEC
• Privileged EXEC
• Global configuration
• Interface configuration
• Config-vlan
• VLAN configuration
• Line configuration

Cisco WS-C3560E-24PD-E Specifications

General

Brand	Cisco
Model	WS-C3560E-24PD-E
Category	Switch
Language	English