Cisco WS-C3560E-24PD-E User Manual

2-388
Catalyst 3560 Switch Command Reference
78-16405-05
Chapter 2 Catalyst 3560 Switch Cisco IOS Commands
show env
show env
Use the show env user EXEC command to display fan, temperature, redundant power system (RPS)
availability, and power information for the switch.
show env {all | fan | power | rps| temperature [status]} [ | {begin | exclude | include} expression]
Syntax Description
Command Modes User EXEC
Command History
Usage Guidelines Though visible on all switches, the show env temperature status command is valid only for the
Catalyst 3560G-48TS, 3560G-48PS, 3560G-24TS, and 3560G-24PS switches. If you enter this
command on these switches, the command output shows the switch temperature states and the threshold
levels. If you enter the command on a switch other than these four switches, the output field shows
Not
Applicable
.
On a Catalyst 3560G-48PS or 3560G-24PS switch, you can also use the show env temperature
command to display the switch temperature status. The command output shows the green and yellow
states as OK and the red state as FAU LT Y. If you enter the show env all command on this switch, the
command output is the same as the show env temperature status command output.
For more information about the threshold levels, see the software configuration guide for this release.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
are not displayed, but the lines that contain Output are displayed.
all Display both fan and temperature environmental status.
fan Display the switch fan status.
power Display the switch power status.
rps Display whether an RPS 300 Redundant Power System is connected to the switch.
temperature Display the switch temperature status.
status (Optional) Display the switch internal temperature (not the external temperature)
and the threshold values. This keyword is available only on the
Catalyst3560G-48TS, 3560G-48PS, 3560G-24TS, and 3560G-24PS switches.
| begin (Optional) Display begins with the line that matches the expression.
| exclude (Optional) Display excludes lines that match the expression.
| include (Optional) Display includes lines that match the specified expression.
expression Expression in the output to use as a reference point.
Release Modification
12.1(19)EA1 This command was introduced.
12.2(20)SE3 The temperature status keyword was added.

Cisco WS-C3560E-24PD-E Specifications

General

Brand	Cisco
Model	WS-C3560E-24PD-E
Category	Switch
Language	English