2-173
Catalyst 3560 Switch Command Reference
78-16405-05
Chapter 2 Catalyst 3560 Switch Cisco IOS Commands
ip igmp snooping vlan static
ip igmp snooping vlan static
Use the ip igmp snooping static global configuration command to enable Internet Group Management
Protocol (IGMP) snooping and to statically add a Layer 2 port as a member of a multicast group. Use
the no form of this command to remove ports specified as members of a static multicast group.
ip igmp snooping vlan vlan-id static ip-address interface interface-id
no ip igmp snooping vlan vlan-id static ip-address interface interface-id
Syntax Description
Defaults By default, there are no ports statically configured as members of a multicast group.
Command Modes Global configuration
Command History
Usage Guidelines VLAN IDs 1002 to 1005 are reserved for Token Ring and FDDI VLANs and cannot be used in IGMP
snooping.
The configuration is saved in NVRAM.
Examples This example shows how to statically configure a host on an interface:
Switch(config)# ip igmp snooping vlan 1 static 0100.5e02.0203 interface gigabitethernet0/1
Configuring port gigabitethernet0/1 on group 0100.5e02.0203
You can verify your settings by entering the show ip igmp snooping privileged EXEC command.
vlan-id Enable IGMP snooping on the specified VLAN. The range is 1 to 1001
and 1006 to 4094.
ip-address Add a Layer 2 port as a member of a multicast group with the specified group
IP address.
interface interface-id Specify the interface of the member port. The keywords have these
meanings:
• fastethernet interface number—a Fast Ethernet IEEE 802.3 interface.
• gigabitethernet interface number—a Gigabit Ethernet IEEE 802.3z
interface.
• port-channel interface number—a channel interface. The range is 0
to 48.
Release Modification
12.1(19)EA1 This command was introduced.
To Next Page
Loading...
Need help?
General