a. Orient one of the rails to identify the front of the rail so that the inside of the
rail is visible with the spacing markings visible.
b. Locate the two screws and nuts which hold the length adjustment bracket in
place.
c. Using a screwdriver and a nut driver (pliers or vise-grips will work as well),
remove both screws and nuts. The length adjustment bracket will be free of
the rail.
d. Move to the front of the rail and align the mounting slots with the mounting
holes near the front of the rail.
Figure 60 18"-22" marking
e. . Slide the inner rail mechanism to the front of the rail until the 18"-22" mark
is visible. If the inner mechanism is locked, depress the leaf spring and press
the rail locking mechanism to free it.
f. Adjust the hardware to make sure the mounting holes are aligned with the
mounting slots.
g. Secure the length adjustment bracket in place using both screws and nuts
that were removed earlier.
h. Repeat for the other rail.
2. To change the length of the rail to 26-30", do the following:
a. Orient one of the rails to identify the front of the rail so that the inside of the
rail is visible with the spacing markings visible.
b. Locate the most forward (closest to the front of the rail) screw and nut
which hold the length adjustment bracket in place.
c. Using a screwdriver and a nut driver (pliers or vise-grips will work as well),
remove the forward-most screw and nut.
d. Slide the length adjustment bracket to the rear of the rail until it stops.
Shelf Installation and Removal
64 EMC Data Domain DS60 Expansion Shelf Installation and FRU Replacement Hardware Guide
To Next Page
Loading...
Need help?
General
