Changing the Network Connection to Ethernet from
the Control Panel
Follow the steps below to change the network connection to Ethernet from Wi-Fi using the control panel.
1. Select Settings on the home screen.
2. Select General Settings > Network Settings > Wi r e d L A N S e t u p .
3.
Tap Start Setup.
4. Check the message, and then close the screen.
e screen automatically closes aer a specic length of time.
5.
Connect the printer to a router using an Ethernet cable.
Disabling Wi-Fi from the Control Panel
When Wi-Fi is disabled, the Wi-Fi connection is disconnected.
1. Tap
on the home screen.
2. Select Router.
e
network status is displayed.
3. Tap Change Settings.
4. Select Others > Disable Wi-Fi.
5.
Check the message, and then start setup.
6. When a completion message is displayed, close the screen.
e screen automatically closes aer a specic length of time.
7. Close the network connection settings screen.
Disconnecting Wi-Fi Direct (Simple AP) Connection
from the Control Panel
Note:
When Wi-Fi Direct (Simple AP) connection disabled, all computers and smart devices connected to the printer in Wi-Fi
Direct (Simple AP) connection are disconnected. If you want to disconnect a
specic
device, disconnect from the device
instead of the printer.
1. Tap on the home screen.
User's Guide
Network Settings
41
To Next Page
Loading...
Need help?
General
Weight and Dimensions
