A.5 Installing Extension System Memory 331
Adding Options
Depending on the current status of the printer, installation of HDD Extension Kit (optional)
or the Feature Enhance Kit (optional) may require installation of Extension System Memory.
For information about memory requirements, refer to the table below.
Procedure for Installing Extension System Memory
This section describes how to install Extension System Memory on the printer.
Note
• The printer has two memory card slots. Slot 1 already has the standard Memory 512 MB installed. Use
Slot 2 to install Extension System Memory.
• Memory capacity can be expanded to a maximum of 1.5 GB by installing a Memory 1024 MB card in Slot
2 and replacing the memory card in Slot 1 with a Memory 512 MB card.
1. Switch the power off by pressing the < >
side of the power switch of the printer.
After checking that the display of the control
panel and the various lamps have switched
off, unplug the power cord from the power
outlet and the printer.
Important
• The electric parts on the inside of the right cover of the
printer can get very hot. Before installing extension
system memory, be sure to first switch off the power of
the printer, wait for approximately 40 minutes, and
check that the temperature inside the printer has
cooled down.
Current Printer Status Adding HDD Extension Kit
Adding a Feature Enhance Kit
(Installation of HDD
Extension Kit also required.)
Main unit only At least 512 MB At least 512 MB
To Next Page
Loading...
Need help?
General
