A.9 Installing the Gigabit Ethernet Board Card (Optional) 345
A.9 Installing the Gigabit Ethernet Board Card
(Optional)
This section describes how to install the Gigabit Ethernet Board Card (optional) on the
printer.
Important
• Parallel Port Kit (Optional) and Gigabit Ethernet Board Card (optional) cannot be installed concurrently. If
the Parallel Port Kit (Optional) is installed, remove the card by reference to “Removing the Parallel Port
Kit (Optional)” (P. 344).
• The interface connecter for standard network cannot be used when the Gigabit Ethernet Board Card
(optional) is installed to the printer.
• When installing both Gigabit Ethernet Board Card (optional) and Feature Enhance Kit, install the Feature
Enhance Kit first.
Installing the Gigabit Ethernet Board Card
1. Switch the power off by pressing the < >
side of the power switch.
After making sure that the control panel
display and all the lamps have gone off,
unplug the power cord from the power
outlet and the printer.
Note
• The electric parts behind the right cover of the printer
can get extremely hot during the printing process.
Before you perform installation, turn off the power and
wait at least 40 minutes for the interior to cool down.
2. Loosen the screw of the rear panel of the
printer, slide the right cover backward, and
remove the cover by pulling the lower side
of the cover towards you.
Gigabit Ethernet Board Card (optional)
To Next Page
Loading...
Need help?
General
