A.12 Installing the KR Additional Font Kit 353
A.12 Installing the KR Additional Font Kit
This section describes how to install the KR Additional Font Kit on the printer.
1. Switch the power off by pressing the < >
side of the power switch of the printer.
After making sure that the control panel
display and all the lamps have gone off,
unplug the power cord from the power
outlet and the printer.
Important
• The electric parts on the inside of the right cover of the
printer can get very hot. Before installing the KR
Additional Font Kit ROM, be sure to first swich off the
power of the printer, wait for approxiamately 40
minutes, and check that the tempretaure inside the
printer has cooled down.
2. Loosen the screw of the rear panel of the
printer, slide the right cover backward, and
remove the cover by pulling the lower side
of the cover towards you.
3. Using a coin, etc., loosen the two screws at
the bottom of the inner cover and remove
the cover.
To Next Page
Loading...
Need help?
General
