334 A Appendix
A.6 Installing the HDD Extension Kit (HDD
Extension Kit)
The installation of the HDD Extension Kit (optional) is required for this printer in the following
cases.
• Functions available only if HDD Extension Kit (optional) is installed
Sample Set / Security Print / Print E-mail / Private Charge Print / Charge Print / Delayed
Print / Font Downloading / feature enhance Kit function / IEEE 802.1x Authentication
function / IPsec Certificate function / ThinPrint function
• Improvement of capabilities with HDD Extension Kit (optional) installation
Number of recorded items (forms) / sort feature performance / spool capability / number of
log
This section describes the procedure for installing the HDD Extension Kit (optional) on the
printer.
Installation procedure
1. Switch the power off by pressing the < >
side of the power switch of the printer.
After checking that the display of the control
panel and the various lamps have switched
off, unplug the power cord from the power
outlet and the printer.
Important
• The electric parts on the inside of the right cover of the
printer can get very hot. Before installing extension
system memory, be sure to first switch off the power of
the printer, wait for approximately 40 minutes, and
check that the temperature inside the printer has
cooled down.
2. Loosen the screw of the rear panel of the
printer, slide the right cover backward, and
remove the cover by pulling the lower side
of the cover towards you.
To Next Page
Loading...
Need help?
General
