Supported commands
D-9
D.2.9 system
D.2.10 track
Command Description
system
Shows the sub commands available, including a short
description.
system restart
Sends a command to the ACU to restart the system
instantaneously. It makes a power-on self test and then
points to the last used satellite.
system info
Shows the software version, part names and serial
numbers of the FV-110.
Table D-10: UCLI command: system
Command Description
track
Shows the sub commands available, including a short
description.
track mode
track mode dvb
Shows or sets the receiver bandwidth or mode, the way
the FV-110 tracks the satellite:
• narrow (recommended, uses the built-in 300 kHz
filter of the FV-110)
• rssi (uses the RSSI signal from the VSAT modem)
• wide (uses the wide-band filter to track the satellite)
• dvb (uses the built-in DVB-S2 receiver of the FV-
110 to track the satellite. You must configure
dvb_sym and dvb_nid.)
• GSC (uses Inmarsat Global Signalling Channel)
• GSCpwr (uses power of Inmarsat Global Signalling
Channel)
track dvb_sym
track dvb_sym 22
Shows or sets the current mega symbols rate for the
DVB-S2 receiver when in dvb mode. The symbol rate
used to verify and track a transponder.
• Valid range: 0.1 — 99
Table D-11: UCLI command: track
To Next Page
Loading...
General