Name: Furuno FV-110
Brand: Furuno
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Configuration with the web interface

5-16

5.3 Configuration with the web interface

5.3.1 Overview and dashboard

Topics in the web interface

Use the site map to get an overview over the existing menus, submenus and topics. You

can click on each menu in the site map to go directly to the page or display the respective

submenu.

Figure 5-14: Topics in the web interface (SITE MAP)

Default Chapter4
- Important Notice4
- Safety Instructions5
- Table of Contents7
Foreword13
System Configuration14
Equipment List15
Chapter 1 Introduction17
- FV-110 System17
- Part Numbers and Options24
  - Applicable FURUNO Model and Part Numbers24
  - Options for FV-11024
Chapter 2 Installation25
- Unpacking25
- Site Preparation27
- Installation of the ADU42
Installation of the ACU50
- To Install the ACU50
- To Ground the ACU51
Installation of the VMU51
- General Mounting Considerations - VMU51
To Install the Dual-Antenna Mode (Optional)52
Chapter 3 Interfaces55
Interfaces of the FV-110 ACU55
- Leds, Display and Keypad55
- ACU Connector Panel - Overview55
- ADU Connector56
- Rx/Tx Connectors for VMU56
- NMEA 0183 Connector57
- And RS-422 Connectors58
- LAN1, LAN2, LAN3 and LAN4 Connectors59
Interfaces of the VMU59
Chapter 4 Connecting Power61
Power up61
- Procedure61
- Initialisation Steps in Daily Use62
- FV-110 Operational62
Chapter 5 Configuration63
Introduction to the Built-In Web Interface63
- Overview63
- Connecting to the Web Interface63
Calibration65
- Heading Mode and Position Mode65
- Azimuth Calibration69
- To Set up a Service Profile for Calibration71
- Cable Calibration73
- Operation in Gyro-Free Mode73
- Flow Chart for Calibration (User Controlled)75
- To Make a Line up Procedure76
- Fixed TX Gain Principle77
- Configuration with the Web Interface78
- Keypad and Menus of the ACU108
- SNMP Support115
Chapter 6 Installation Check117
- Installation Check List: Antenna117
- Installation Check List: ACU, Connectors and Wiring119
- Installation Check List: Functional Test in Harbor121
Chapter 7 Service123
- Getting Support: Helpdesk123
  - Help Desk and Diagnostic Report123
- Software Update126
- Status Signalling with Leds and Status Messages129
  - Leds of the ADU Modules129
  - Leds in the ACU130
- Removal and Replacement of the ACU130
- Removal and Replacement of ADU Modules131
- Troubleshooting134
- Returning Units for Repair134
Appendix A Data Sheets135
VSAT LNB Data Sheet (Physical LNB135
- VSAT LNB User Installation and Configuration Information136
VSAT 8 W BUC Data Sheet (Extended137
Appendix B VMU Cables140
Modem Cable COMTECH Serial & RSSI TT7016A140
Modem Cable Infiniti Idirect VSAT Modem141
Appendix C VMU Settings143
Performance Optimization for Blockage143
- Performance of VSAT Systems Encountering Blockage, Configured with Multiple Satellites143
Openamip Setup for Idirect Infiniti & Evolution145
- Protocol and Interfaces145
- Sample Options File148
- Configuration Example (Openamip151
- Troubleshooting152
Serial Setup for Idirect Infiniti & Evolution155
- Protocol and Interfaces155
- Console Port Settings155
- Configuration Example (Serial157
COMTECH 570L and ROSS Box159
- Protocols and Interfaces159
- Configuration Example (COMTECH 570L and ROSS160
Comtech 570L161
- Protocol and Interfaces161
- C.5 Comtech 570L161
- Configuration Example (COMTECH 570L163
STM Satlink 2900 VSAT Modem164
- Interfaces and VSAT Modem Configuration164
- ACU Configuration166
- Configuration Example (STM Satlink 2900167
Gilat Skyedge II VSAT Modem168
- Interfaces and VSAT Modem Configuration168
- ACU Configuration169
- Configuration Example (Gilat Skyedge II170
Inmarsat G5 Modem171
- Interfaces and VSAT Modem Configuration171
- Connecting a Inmarsat G5 Modem171
- Inmarsat G5 Driver171
- C.8 Inmarsat G5 Modem171
- ACU Configuration172
- Configuration Example (Inmarsat G5173
- LAN Setup Requirements for G5 System173
Linkway S2 Modem174
- Protocols and Interfaces174
- C.9 Linkway S2 Modem174
- ACU Configuration176
- Configuration Example (Linkway S2177
Appendix D Command Line Interface179
Introduction179
- Telnet Connection179
- D.1 Introduction179
- Help180
- Conventions180
Supported Commands181
- Config181
- Demo181
- Satellite181
- D.2 Supported Commands181
- D.2.6 Modem183
- D.2.8 Status186
- Track187
- D.2.9 System187
- Zone188
Appendix E DVB-S Satellites193
Appendix F Grounding and RF Protection193
Why Is Grounding Required193
- Reasons for Grounding193
- Safety193
- ESD Protection193
- F.1 Why Is Grounding Required?193
Grounding Recommendations194
- To Ground the ACU194
- To Ground the ADU194
- F.2 Grounding Recommendations194
Alternative Grounding for Steel Hulls195
- To Ground the ACU195
- To Ground the ADU196
Alternative Grounding for Aluminum Hulls197
- To Ground the ACU197
- To Ground the ADU197
Alternative Grounding for Fibre Glass Hulls198
- To Ground the ACU198
- To Ground the ADU198
Separate Ground Cable199
- Ground Cable - Construction199
- Ground Cable - Connection200
- Isolation of the ADU from the Mounting Base200
Jumper Cable for Grounding202
RF Interference203
- Recommendations203
- F.8 RF Interference203
Appendix G System Messages205
Event Messages - Overview205
List of ADU Events206
List of ACU Events212
Appendix H Approvals217
Overview217
OEM Declaration218
Ce (R&Tte219
- H.3 Ce (R&Tte)219
Eutelsat S.A - ESV Summary Sheet220
Russian Maritime Register of Shipping221
ANATEL Certificado de Homologação224
Specifications225
Index233

Questions and Answers:

Need help?

Do you have a question about the Furuno FV-110 and is the answer not in the manual?

Furuno FV-110 Specifications

General

Brand	Furuno
Model	FV-110
Category	Antenna
Language	English

Furuno FV-110 User Manual

Table of Contents

Questions and Answers:

Furuno FV-110 Specifications