RF interference
F-11
F.8 RF interference
Interference induced from nearby high-power RF transmitters might cause system failures
and in extreme cases permanent damage to the FV-110 equipment. If there are problems
with interference from HF transmitters, it is advisable to mount ferrite clamps on the coax
cable in order to provide suppression of induced RF. The ferrites will have no effect on
the differential-mode signals but increases the impedance in relation to common-mode
RFI.
F.8.1 Recommendations
Use 1-5 pcs. hinged clamp cores (e.g. the RFC or SFC series from Kitagawa) mounted on
the ADU cable near the ADU.
To Next Page
Loading...
General