Configuration with the web interface
5-32
5.3.6 Reports, syslog and SNMP traps
The antenna can send the following reports and messages:
• Diagnostics report
• Statistics report
• Remote syslog
• SNMP traps
Diagnostics report
You can send automatically generated diagnostic reports at fixed intervals. The diagnostic
report contains information from the ADU and ACU that are relevant for the service
personnel during troubleshooting. The report contains data for the selected download
intervals.
To set up sending a statistics report, do as follows:
1. Select SETTINGS > Reporting.
2. In the section DIAGNOSTICS REPORT enter the following:
• E-mail sender.
• E-mail recipients (comma separated).
• Send interval: Select e-mail disabled, day (default, 2-minute samples), week
(hourly samples) or month (hourly samples).
3. Click Apply.
You can generate and send the diagnostic report at any time by clicking Send now. You
can also download a diagnostics report directly to your computer, go to the page
HELPDESK and click Download. For more details see To download diagnostic and
statistics reports on page 7-2.
When getting the log data between the ACU and the modem, select the check box for
Modem on the HELPDESK > Support page. The ACU-modem communication log is
added to the diagnostics report.
Note: Be aware that ACU-modem communication will fill up the log very quickly as
status commands are sent very often.
Statistics report
FV-110 can send a statistics report at fixed intervals. This report contains historical
information from the FV-110 of up to 1 month. It is sent as a zipped attachment to an e-
mail. The file format is a comma separated value file (csv). The report can then be
processed in spreadsheet applications, e.g. Microsoft Excel.
To set up sending a statistics report, do as follows:
1. Configure e-mail first, see E-mail setup on page 5-31.
2. Go to SETTINGS > Reports.
3. In the section STATISTICS REPORT enter the following:
• Email sender.
• Email recipients (comma separated).
To Next Page
Loading...
General