1 Introduction
7
10 4 x Battery pack screws
11 Internal battery handle
12 DC fuse
13 AC fuses
14 DC cord connector
15 Grounding pin
16 AC cord connector
17 Cooling fan
CAUTIONS AND WARNINGS
CAUTION The iVent
TM
201 is a restricted medical device to be operated by
qualified medical personnel under the direction of a qualified medical
practitioner
Always perform a complete Operation Verification Test (O.V.T.) when
connecting a new patient circuit to the ventilator, and before using it
on a patient. Standard facility policy should be followed.
Using the iVent
TM
201 in combination with devices such as humidifiers
or filters can increase the pressure gradient across the breathing
system. Make sure that such devices do not produce excessive
resistance to the airflow provided by the iVent
TM
201.
The iVent
TM
201
must not be operated immediately following storage
or transport outside the recommended operation condition
The iVent
TM
201 internal battery contains lead and must be disposed of
in accordance with local ordinances and environmental regulations.
Do not connect the O2 supply when equipment is not in use.
The remote alarm should be considered secondary to the ventilator’s
primary alarm system.
Verify the remote alarm device functionality before use
The remote alarm connector should be connected to a nurse station
device on a low voltage less than 24Vdc and compliant with IEC
60601-1.
The factory default setting for Leak Alarm is set to Off. Users must
manually set the leak alarm to enable it.
WARNING The iVent
TM
201 is a life-sustaining device. Do not rely solely on the
ventilator performance: always make sure an alternative source of
ventilation is available. Clinical supervision of the patient is
To Next Page
Loading...
Need help?
General
