Measurement and Analysis
Vivid S5/Vivid S6 User Manual 367
R2424458-100 Rev. 2
To select a fetus
During measurements and calculations, to change between
fetuses, do one of the following:
• Adjust the Fetus selection.
• Move the Trackball to the Summary Window and select
the fetus.
Figure 7-69: Summary Window: Multiple fetus
You can change between fetuses at any time during the exam.
Note: After you change to the next fetus, any measurements
you make are recorded and reported to that fetus. If you have
any active measurement or calculation that is not completed
when you change the fetus, the system cancels the
measurement or calculation.
To compare multiple fetus data on a
worksheet
With multiple fetuses, you can list and compare measurements
of the fetuses on the worksheet.
• Select Worksheet Display.
• Select Fetus Compare.
The system lists the measurement results for each fetus
on the Worksheet.
To Next Page
Loading...
Need help?
General
