D
IRECTION FR091521, REVISION 1 VIVID S60N/VIVID S70N BASIC SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-49
PRELIMINARY
8-3-8 Operator Panel Label Replacement Procedure
NOTE: The Operator Panel is supplied without the Vivid™ S60 or Vivid™ S70 label - these are separate parts.
When the OPIO is replaced, order the appropriate label when ordering the OPIO replacement part - see
below:
• The Vivid™ S60N label identifies the 2D scanner
• The Vivid™ S70N label identifies the 4D scanner
8-3-8-1 Tools
Blunt instrument for removing Vivid S60/S70 label from the Operator Panel.
8-3-8-2 Operator Panel Label Removal Procedure
1.) Using a blunt instrument carefully remove the existing label from the OPIO panel.
2.) Clean the area from where the label was removed and prepare the surface for adhering the
replacement label.
8-3-8-3 Operator Panel Label Installation Procedure
1) Prior to adhering the label, ensure the surface of the Operator Panel is clean, dry, and free of
particles.
2) Remove the self-adhesive label from it’s packing.
3) Peel back the plastic protective outer layer from the label and remove it to expose the adhesive
surface.
4) Carefully place the label in position on the Operator Panel ensuring that it is correctly oriented
(upright), straight and parallel to the inlaid impression on the Operator Panel - see Figure 8-55.
5.) Using a soft, clean cloth, gently press out any air bubbles that might be trapped behind the label.
Refer to Table 9-11 on page 9-10
Figure 8-55 Location of Operator Panel Label
To Next Page
Loading...
Need help?
General
