HEIDENHAIN ITNC 530 Service Manual

July 2010 12 – 167
Which file type is
to be listed?
File information
Use this key to switch between soft-key rows.
File name Name consists of up to 25 characters plus file extension
Byte File size in bytes
Status File properties:
E The file is selected in Programming and Editing
S The file is selected in Test Run (simulation)
M File selected in a Program Run mode of operation
P Protected file that cannot be deleted or edited
+ This file has dependent files (see User's Manual)
Date Date on which file was last changed
Time Time at which the file was last changed
Note
Refer to the iTNC 530 User’s Manual for detailed information about file
management!

HEIDENHAIN ITNC 530 Specifications

General

Control Type	CNC
Look-ahead	Yes
Spindle control	Yes
Touch probe cycles	Yes
Operating voltage	24 V DC
Programming	Conversational and DIN/ISO programming
Interpolation	Linear, Circular, Helical
Data Interface	Ethernet, USB, RS-232
Memory	1 GB
Programming Language	HEIDENHAIN plain language
Operating Modes	Manual, Automatic, MDA
Software Options	Various software options available