July 2010 29 – 561
29 Measuring, Testing and Inspection Equipment
29.1 Important Notes
Observe the safety precautions in chapter 2 of this manual. --> See “Safety Precautions”
on page 2 – 15!
The following inspection, measuring and testing equipment is only intended for testing
machines!
Encoder cables, etc., are no longer continuously shielded when the test adapter is
connected.
When using grounded measuring equipment (e.g., oscilloscope with power connection),
always the socket of the machine's electrical cabinet should be used for power supply.
Compensating currents caused by different earth potentials can thus be avoided!
For measuring voltages, first connect to 0 V and only then to the voltage to be measured!
Always observe the Operating Instructions of PWM 9 as well as the Operating
Instructions of PWT 10/17/18 and IK 215!
To Next Page
Loading...
Need help?
General
