HEIDENHAIN ITNC 530 Service Manual

30 – 616 HEIDENHAIN Service Manual iTNC 530
30.4.11 Tapping
MP Function and input SW version
and
behavior
MP7110.0 Minimum for feed-rate override during tapping
Input: 0 to 150 [%]
PLC
RUN
MP7110.1 Maximum for feed-rate override during tapping
Input: 0 to 150 [%]
MP7120.0 Dwell time for reversal of spindle rotational direction
Input: 0 to 65.535 [s]
PLC
RUN
MP7120.1 Advanced switching time of the spindle during tapping with coded spindle-speed output
Input: 0 to 65.535 [s]
MP7120.2 Spindle slow-down time after reaching the hole depth
Input: 0 to 65.535 [s]
MP7130 Run-in behavior of the spindle during rigid tapping
Input: 0.001 to 10 [°/min]
PLC
RUN
MP7150 Positioning window of the tool axis during rigid tapping
Input: 0.0001 to 2 [mm]
PLC
RUN
MP7160 Spindle response during Cycles 17, 207 and 18
Format: %xxxxx
Input: Bit 0 – Oriented spindle stop with Cycles 17 and 207
0: Oriented spindle stop before execution of the cycle
1: No oriented spindle stop before execution of the cycle
Bit 1 – Spindle speed
0: Spindle speed is not limited
1: Spindle speed is limited so that it runs with constant speed approx. 1/3 of the time
Bit 2 – Spindle in position feedback control
0: Spindle operated without position feedback control
1: Spindle operated with position feedback control
Bit 3 – Acceleration feedforward control
0: Active
1: Not active
Bit 4 –
0: Tool axis tracks the spindle
1: Tool axis and spindle interpolated
PLC
RUN
CN123

HEIDENHAIN ITNC 530 Specifications

General

Brand	HEIDENHAIN
Model	ITNC 530
Category	Control Systems
Language	English