HEIDENHAIN ITNC 530 Service Manual

July 2010 13 – 171
Protection from
data tampering
It is possible that the machine manufacturer has activated the following soft key on the
iTNC 530.
Before data are read from or written to the control's hard disk, such an action must be approved.
8 Press the MOD key and subsequently the soft key EXTERNAL ACCESS ON/OFF.
--> The access must be approved!
Note
The external access (via laptop/PC) to partitions on the control's hard disk (e.g., PLC
partition) can be locked with passwords by the machine manufacturer, like the internal
access (on the control).
Contact the machine manufacturer!

HEIDENHAIN ITNC 530 Specifications

General

Control Type	CNC
Look-ahead	Yes
Spindle control	Yes
Touch probe cycles	Yes
Operating voltage	24 V DC
Programming	Conversational and DIN/ISO programming
Interpolation	Linear, Circular, Helical
Data Interface	Ethernet, USB, RS-232
Memory	1 GB
Programming Language	HEIDENHAIN plain language
Operating Modes	Manual, Automatic, MDA
Software Options	Various software options available