HEIDENHAIN ITNC 530 Service Manual

18 – 310 HEIDENHAIN Service Manual iTNC 530
IK 215 Use the IK 215 interface card for inspecting and testing an EnDat encoder. --> See “IK 215
Adjusting and Testing Package” on page 29 – 570
DANGER
If the IK 215 is connected in the signal path between the encoder and the control
component:
Do not change the settings of the IK 215 (e.g., parameters, encoder voltages) and do not
switch it off while the machine tool is operating.
This could lead to damage or injury to the machine or persons!
Read the operating instructions of the IK 215 in detail, before you use the unit.
Note
A detailed explanation of the device is part of our training courses on measuring systems.
We recommend that you participate in a HEIDENHAIN service training course so that you
can use the IK 215 correctly and effectively.
Contact HEIDENHAIN Traunreut or your regional agency.

HEIDENHAIN ITNC 530 Specifications

General

Control Type	CNC
Look-ahead	Yes
Spindle control	Yes
Touch probe cycles	Yes
Operating voltage	24 V DC
Programming	Conversational and DIN/ISO programming
Interpolation	Linear, Circular, Helical
Data Interface	Ethernet, USB, RS-232
Memory	1 GB
Programming Language	HEIDENHAIN plain language
Operating Modes	Manual, Automatic, MDA
Software Options	Various software options available