28 – 526 HEIDENHAIN Service Manual iTNC 530
Feature Content
Level
When a new version is released as of NC software 340490-xx (with smarT.NC programming
surface), the ranges for error fixes and expanded functions are managed separately.
When the NC software is updated to a new version, only the included error fixes will initially be
effective.
If the new features of this NC software version are also required, they can be ordered and
subsequently be enabled by a code number. --> Ask the machine manufacturer!
The Feature Content Level is now numbered consecutively:
The Feature Content Level is shown in the code number window. --> See “Important
Features of HEIDENHAIN Components” on page 26 – 429.
The number shown cannot be higher than the NC software version (i.e., for NC software
340490-04, the highest possible Feature Content Level is 4).
A higher Feature Content Level always includes the features of the previous versions.
Electronic ID label Some HEIDENHAIN units feature an electronic ID label.
The product name, the ID number and the serial number are saved in this ID label.
Prerequisite for the evaluation of the electronic ID labels of the iTNC 530:
Under these conditions, the devices are automatically detected when the control is started.
During every control restart, the control checks whether the connected units with electronic
ID label match the entries in MP2100.x or MP2200.x.
As of NC software
version
Machine parameters Current units with electronic ID
label
340422-06 MP 7690 is active HEIDENHAIN inverter with "D" in
the device name, e.g., UM 112D
340480-06 HEIDENHAIN synchronous motors
with rotary encoders with EnDat
interface
To Next Page
Loading...
Need help?
General
