HEIDENHAIN ITNC 530 Service Manual

July 2010 30 – 623
MP7310 Graphic display mode
Format: %xxxxxxxx
Input: Bit 0 – Projection in three planes:
0: German-preferred projection
1: US-preferred projection
Bit 1 – Rotating the coordinate system in the working plane by 90°:
0: No rotation
1: Rotation by +90°
Bit 2 – BLK form after datum shift:
0: Shifted
1: Not shifted
Bit 3 – Display of the cursor position:
0: Not displayed
1: Displayed
Bit 4 – Reserved
Bit 5 – 3-D graphics during program test
0: 2,5 D and 3 D (only with MC 420 or MC 422B and higher)
1: 2,5 D
Bit 6 – Reserved
Bit 7 – Reserved
PLC
RUN
CN123
MP7312 Limitation of the tool tooth length LCUTS if no value was given for the tooth length in
the tool table
Input:
0 = No limitation, infinitely long tooth length
> 0: Tooth length = 2 * tool radius * MP7312
PLC
RUN
MP7315 Tool radius for graphic simulation without TOOL CALL
Input: 0.0000 to 99 999.9999 [mm]
PLC
RUN
CN123
MP7316 Penetration depth of the tool
Input: 0.0000 to 99 999.9999 [mm]
PLC
RUN
CN123
MP7317 M function for graphic simulation PLC
RUN
CN123
MP7317.0 Beginning of graphic simulation
Input: 0 to 88
MP7317.1 Interruption of the graphic simulation
Input: 0 to 88
MP7330.0-15 Specification of user parameters 1 to 16
Input: 0 to 9999.00 (no. of the user parameter)
PLC
RUN
MP7340.0-15 Dialog messages for user parameters 1 to 16
Input: 0 to 4095 (line number of the PLC dialog message file)
PLC
RUN
MP Function and input SW version
and
behavior

HEIDENHAIN ITNC 530 Specifications

General

Brand	HEIDENHAIN
Model	ITNC 530
Category	Control Systems
Language	English