1-52
OPERATOR'S STATION
Auto Idling Stop
d
WARNING: This function automatically idles, then
stops the engine. Take extra care on the work and
environment when using this function.
The auto Idling Stop (Shut Down) function can be set in this
screen. Set the auto Idling Stop time and enable the function
beforehand (set to ON).
The engine automatically stops after the preset time when
machine is parking under the following conditions:
- Parking brake switch: ON (parking brake is applied)
- Service brake pedal: released (service brake pedal is not
applied)
- Throttle pedal: released
- Transmission position: Neutral
- No steering wheel or loading lever operation
30 seconds before the engine stops, the monitor displays a
message that the engine will be stopped and the indicator
(7) starts flashing. The buzzer also sounds. The buzzer sounds
once at 30 seconds before, intermittently sounds from 15
seconds, and then stops after 15 seconds. When the machine
is in the operating state or any of the above listed conditions
is not satisfied before stopping the engine, the auto idling stop
is disabled and the engine will not stop.
IMPORTANT: Do not leave the machine after auto idling
stop. Failure to do so may discharge the batteries.
Auto idling stop: ON/OFF
1. Press selector knob (2) while displaying Basic Screen (1)
to display Main Menu screen (3).
2. Rotate selector knob (2) to highlight Setting Menu (4).
3. Press selector knob (2) to display Setting Menu screen
(5).
4. Rotate selector knob (2) to highlight Auto Shut-Down (6).
2
MNEC-01-006
1
3
4
7
MPD8-01-100EN
MNEK-01-140EN
5
6
MNEK-01-150EN
To Next Page
Loading...
Need help?
General
