S-8
SAFETY
Move and Operate Machine Safely
Bystanders can be run over.
Take extra care not to run over bystanders. Be advised
that there may be blind spots with rear view camera.
Confirm the location of bystanders before moving,
swinging, or operating the machine by sight and mirrors
as well as the rear view monitor.
Always keep the travel alarm and horn in working
condition (if equipped). It warns people when the
machine starts to move.
Use a signal person when moving, or operating the
machine in congested areas. Coordinate hand signals
before starting the machine.
Use appropriate illumination. Check that all lights are
operable before operating the machine. If any faulty
illumination is present, immediately repair it.
Ensure the cab door, windows, doors and covers are
securely locked.
Check the mirrors and the monitor in the CAB for
problems.
If there is, replace the problem part(s) or clean the mirror,
camera and the monitor.
Refer to Rear View Monitor section on the cleaning of the
camera and the monitor.
Handle Starting Aids Safely
Starting fluid:
Starting fluid is highly flammable.
Keep all sparks and flame away when using it.
Keep starting fluid well away from batteries and cables.
Remove container from machine if engine does not need
starting fluid.
To prevent accidental discharge when storing a
pressurized container, keep the cap on the container, and
store it in a cool, well-protected location.
Do not incinerate or puncture a starting fluid container.
SA-293
SA-398
To Next Page
Loading...
Need help?
General
