1-20
OPERATOR'S STATION
Default Setting
Function Item Default
Auto Shut-Down ON/OFF of auto idling-stop function ON
Time period for auto shut-down activation 5 min
Rear View Camera Monitor ON (Constant display)
OFF (No display)
AUTO (Display at reverse operation only)
AUTO
Aftertreatment Device Regeneration
Inhibit
Inhibit regeneration OFF
Shift Change Delay Mode
(Transmission Setting)
ON/OFF of travel speed (shift) change delay mode OFF
Parallel/Tandem Switching Height Height at parallel or tandem circuit operation are
switched
Lift arm is level to the
ground
Warm Up Increases engine speed at engine start to help
warm up in cold environment
OFF
f
NOTE: Typical functions are shown in the table. Check the initial values of other functions on each monitor screen.
To Next Page
Loading...
Need help?
General
