OPERATOR'S STATION
1-107
MNEC-01-043
4
Quick Power Switch
By pressing quick power switch (4) when the power mode
is OFF, the power mode is temporarily activated. (The
power mode indicator on the monitor shows symbol ( ).)
f
NOTE: The quick power switch is operable only in the
following cases.
An added push is needed during digging (tractive)
operation.
Need a little more acceleration or travel speed while
ascending on a slope.
When operating under low load or the forward/reverse
lever is in "Neutral" (N) position, the mode will not change
to power mode even if quick power mode switch is
pressed. The switch selection is ruled invalid.
Also, even if the machine is in the power mode, it is
canceled when the following conditions are met.
When operating load is decreased while digging.
When the quick power mode switch is pressed.
The forward/reverse lever or forward/reverse switch is
shifted.
While driving in the auto-shift mode, the gear shifts
up to the selected gear stage.
MNEC-01-042
4
To Next Page
Loading...
Need help?
General
