S-31
SAFETY
Beware of Exhaust Fumes
Prevent asphyxiation. Engine exhaust fumes can cause
sickness or death.
If you must operate in a building, be sure there is
adequate ventilation. Either use an exhaust pipe
extension to remove the exhaust fumes or open doors
and windows to bring enough outside air into the area.
White smoke may be generated during aftertreatment
device regeneration. Do not attempt to do aftertreatment
device manual regeneration in a badly ventilated indoors.
Precautions for Welding and Grinding
Welding may generate gas and / or small fires.
Be sure to perform welding in a well ventilated and
prepared area. Store flammable objects in a safe place
before starting welding.
Only qualified personnel should perform welding.
Never allow an unqualified person to perform welding.
Grinding on the machine may create fire hazards. Store
flammable objects in a safe place before starting grinding.
After finishing welding and grinding, recheck that there are
no abnormalities such as the area surrounding the welded
area still smoldering.
Avoid Heating Near Pressurized Fluid Lines
Flammable spray can be generated by heating near
pressurized fluid lines, resulting in severe burns to yourself
and bystanders.
Do not heat by welding, soldering, or using a torch near
pressurized fluid lines or other flammable materials.
Pressurized lines can be accidentally cut when heat goes
beyond the immediate flame area. Install temporary
fire-resistant guards to protect hoses or other materials
before engaging in welding, soldering, etc..
SA-030
SA-016
SA-818
To Next Page
Loading...
Need help?
General
