Juniper MX10008 User Manual

Table 11: Fan Tray LEDs on an MX10008 Router (continued)
DescriptionStateColorName
The center SFB behind the right fan tray
is online.
On steadilyGreenSFB 4 status
The beacon feature is enabled. This feature
is enabled using the request chassis
beacon command.
BlinkingGreen
An error has been detected in SFB 4.
Replace the SFB as soon as possible. The
SFB is located behind the right fan tray and
is the middle SFB in the grouping of 3. To
maintain proper airflow through the
chassis, leave the fan tray installed in the
chassis until you are ready to replace the
SFB.
BlinkingYellow
The SFB is offline.OffNone
The right-most SFB behind the right fan
tray is online.
On steadilyGreenSFB 5 status
The beacon feature is enabled. This feature
is enabled using the request chassis
beacon command.
BlinkingGreen
An error has been detected in SFB 5.
Replace the SFB as soon as possible. The
SFB is located behind the right fan tray and
is the right-most SFB in the grouping of 3.
To maintain proper airflow through the
chassis, leave the fan tray installed in the
chassis until you are ready to replace the
SFB.
BlinkingYellow
The SFB is offline.OffNone
Fan Tray Controller LEDs
Both models of fan controller (JNP10008-FAN-CTRL and JNP1008-FTC2) have the same LEDs. The fan
tray controller LEDs are only visible when the associated fan tray is removed. The fan tray controller LEDs
57

Juniper MX10008 Specifications

General

Brand	Juniper
Model	MX10008
Category	Network Router
Language	English