Log in to the instrument
The web interface has both interactive and read-only pages. These pages are always listed in the
navigation panel on the left side of the web interface. You can review information on any of the pages
without logging in, but to change information, you must log in.
Pages that contain information you can change include a Login button. Once you have logged in to
one page of the web interface, you do not need to log in again unless you reload the page.
To log in to the instrument:
1. Open a page that contains a Login button, such as one of the Cards pages, Scan Builder, or TSB
Embedded.
Figure 36: Web interface login
2. Click Login. The login dialog box is displayed.
3. Enter the password (the default is admin).
Figure 37: Enter web interface password
4. Click Login.
The default password is admin. If the password has been changed, it is available from the front
panel of the instrument. Press MENU > LAN > STATUS > PASSWORD.
Card pages
The card pages are interactive pages where you can work with channels in each slot.
To open a card page, on the left navigation, click the slot number.
There is a specific page for each card installed in the mainframe. The page displays a grid that shows
the relay configuration of the switch card.
To Next Page
Loading...
Need help?
General
