Revision:1.0(2023-01-12)
137
Procedure Acceptance criteria
Tap L/R Flip in the image menu for adjustment.
The
mark indicates the default
orientation of an image in the upper left
corner.
iClear
Tap iClear in the image menu for adjustment.
Range:
Off, 1-7
V1:1 (only for linear array probes)
Tap ImageMenu>V1:1 for adjustment.
The Dual function needs to be turned on for
V1:1.
Patient Temperature (only for TEE)
Tap ImageMenu>Patient Temperature for
adjustment.
It is displayed in the upper left corner in the
image area.
iBeam
Tap ImageMenu>iBeam for adjustment.
Range:
Off, 1-3
Gray Map
Tap ImageMenu>Gray Map for adjustment.
Tap -/+ to select maps.
There are 8 different maps available.
Tint Map
Tap ImageMenu>Tint Map for adjustment.
Tap -/+ to select maps.
There are 8 different maps available.
ExFov
Tap ImageMenu>ExFov for adjustment.
Range:
Off, 1, 2
TSI
Tap ImageMenu>TSI for adjustment.
The system provides four ways of
optimization for specific tissues: general,
muscle, fluid and fat.
Dehaze
Tap ImageMenu>Dehaze for adjustment.
Tap -/+ for fine tune or directly drag the sliding
block for quick tune.
Range: 0 to 30
FOV (%)
Tap ImageMenu>FOV for adjustment.
Imaging Display Adjustment
Tap -/+ for fine tune or directly drag the sliding
block for quick tune.
Persistence
Tap ImageMenu>Persistence for adjustment.
Tap -/+ for fine tune or directly drag the sliding
block for quick tune.
Range: 0 to 7
Smooth
Tap ImageMenu>Smooth for adjustment.
Tap -/+ for fine tune or directly drag the sliding
block for quick tune.
Range: 0 to 6
Line Density
Tap ImageMenu>Line Density for adjustment.
Four levels of line density are provided,
including UH, H, M, and L.
A. Power Range: 0.4%-100%
Diagnostic Ultrasound System
Service Manual
4 Function and Performance
Check
To Next Page
Loading...
Need help?
General
