6-19
• Resetting of maintenance information
After replacing a periodic replacement item such as
the oil, filter element, or engine coolant, reset the
maintenance information for the item as follows:
1. Press the MODE switch to select the mainte-
nance information mode.
2. Press the SELECT switch to select the item
for which the maintenance information is to be
reset.
3. Give a long press (1 second or more) on the
SET/RES switch to reset the maintenance
information.
NOTE:
Do the same procedure after replacing any periodic
replacement item.
3.7 Illumination intensity (brightness adjust-
ment)
• Selection and adjustment of illumination
intensity
• Both the illumination intensity screen and the
adjustment screen provide different displays
between the time when the light switch is in the
“OFF” position and the time when the switch is
in the or position as follows:
• When the light switch is in the “OFF” posi-
tion, the multi-information display indicates
“DISP (DAY)” or “GAUGE (DAY)”. In this
state, the brightness of the displays or
gauges under no illumination condition (day-
time) is adjustable.
• When the light switch is in the or
position, the multi-information display indi-
cates “DISP (NIGHT)” or “GAUGE (NIGHT)”.
In this state, the brightness of displays or
gauges when lit (nighttime) can be adjusted.
• The brightness of the following display and
gauges can be adjusted as follows.
• When “DISP (DAY)” or “DISP (NIGHT)” is
displayed:
Multi-information display
• When “GAUGE (DAY)” or “GAUGE (NIGHT)”
is displayed:
DEF level indicator
• When “GAUGE (NIGHT)” is displayed:
Illumination of the air conditioner control
panel and the scales of the speedometer,
tachometer, and fuel gauge (when the light
switch is in the or position)
Z21561
Z21562
FE_FG.book Page 19 Tuesday, February 8, 2011 4:00 PM
To Next Page
Loading...
Need help?
General
