EasyManuals Logo
Home>Mitsubishi>Automobile>FUSO FE 2012

Mitsubishi FUSO FE 2012 User Manual

Mitsubishi FUSO FE 2012
481 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #150 background imageLoading...
Page #150 background image
6-31
1 Vacuum pressure warning lamp
This lamp illuminates when the starter switch is
turned to the “ON” position. As long as the lamp
goes out when the engine is started, the vehicle
may be driven. If illuminated while the engine is run-
ning, this lamp signals that the vacuum level in the
brake vacuum tank has dropped below the safe
limit.
This lamp, when illuminated, signals that the vac-
uum level in the brake vacuum tank has dropped
below the safe limit.
Since braking becomes sluggish under this condi-
tion, depress the brake pedal with full force to slow
down the vehicle, then pull off the road as soon as it
is safe to do so, and perform the following checks:
1. Let the engine run at intermediate RPM until the
warning lamp goes out.
2. Check piping and its connections for vacuum
leaks.
3. If the lamp does not go out or comes on again
soon after it has gone out, the vacuum system is
defective and must be repaired. Call an autho-
rized dealer.
WARNING
Braking is dangerously sluggish when the
vacuum warning lamp is illuminated. For
safety, never drive with the vehicle in this
condition.
Z10909
FE_FG.book Page 31 Tuesday, February 8, 2011 4:00 PM

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mitsubishi FUSO FE 2012 and is the answer not in the manual?

Mitsubishi FUSO FE 2012 Specifications

General IconGeneral
BrandMitsubishi
ModelFUSO FE 2012
CategoryAutomobile
LanguageEnglish

Related product manuals