10-30 Interior equipment and accessories
5. Press the power/volume knob to complete the
clock setting.
The original display will resume about 5 sec-
onds later.
6Alarm
If you set the alarm to the desired time, a buzzer will
sound at the preset time.
NOTE:
The alarm time setting is cancelled if the battery is
disconnected or the associated fuse is removed.
You will then need to set the alarm time again.
6.1 Setting the alarm time
1. Press the “ALARM” button to switch to the alarm
time display.
2. With the alarm time appearing on the display,
give the “DISP” button a long press. A short
beep will sound, and the hour part of the alarm
time display will start flashing.
Z21093
Z21094
Z21849
FE_FG.book Page 30 Tuesday, February 8, 2011 4:00 PM
To Next Page
Loading...
Need help?
General
