14-3
2 Recommended lubricants/hydraulic fluids
Be sure to use the specified lubricants.
*1: At ambient temperatures higher than 10°C (50°F), use an oil conforming to GL-5, SAE140 or
SAE85W-140 if the vehicle is used under such a heavy load conditions as continuous upgrade climb-
ing.
Parts Category Classification
Viscosity
Atmospheric
temperature
SAE viscosity
number
Engine Engine oil
API CJ-4
Below 0°C (32°F) 10W–30
Above –15°C (5°F) 15W–40
Above 30°C (86°F) 40
ACEA C2 Below 0°C (32°F) 5W–30
Transmission
Transfer <FG>
Gear oil
API GL-3
General 80
Warm region 90
API GL-4 Tropical region 90
Engine oil
<not applicable to
transfer>
API CC
Long period of high-
speed driving
30 or 40
Clutch
Automatic transmis-
sion fluid
FUSO ATF SP III – –
Axle housing
*1
Gear oil API GL-5
Below 40°C (104°F) 90
Above 40°C (104°F) 140 or 85W–140
Limited-slip
differential <vehicles
with limited slip differ-
ential>
Gear oil for limited-
slip differential
API GL-5
Genuine Gear Oil,
Part No. 8149630EX
–90
Power steering
Automatic transmis-
sion fluid
DEXRON II or
DEXRON III type
––
Brake Brake fluid
SAE J1703,
FMVSS No. 116
(Grade DOT3)
––
Chassis grease
nipples (rear spring
pin, king pin)
Door hinge
Anchor hooks
<Vehicles other than
Crew-cab models>
Chassis grease
NLGI No. 1 (Li soap)
Consistency 310 to
340 (at 25°C or 77°F)
Dropping point 130°C
(266°F) or higher
––
Wheel hub bearing
Propeller shaft
(universal joint, slip
joint, double cardan
joint <FG>)
Wheel bearing
grease
(Multipurpose type
grease)
NLGI No. 2 (Li soap)
Consistency 265 to
295 (at 25°C or 77°F)
Dropping point 185°C
(365°F) or higher
––
Propeller shaft center
bearing
Bearing grease
NLGI No. 3 (Li soap)
Consistency 220 to
250 (at 20°C or 68°F)
Dropping point 250°C
(482°F) or higher
Usable temperature
range –40 to 150°C
(–40 to 302°F)
––
FE_FG.book Page 3 Tuesday, February 8, 2011 4:00 PM
To Next Page
Loading...
Need help?
General
