5-39
3. When the desired speed is reached, turn the
RESUME/SET switch toward the “SET” side.
The indicator lamp will illuminate indicating
that the cruise control is activated. Now the
desired speed is memorized, so release the
accelerator pedal. The vehicle will run maintain-
ing that speed automatically.
NOTE:
• If you activate the cruise control while driving
with the DUONIC
TM
system in the manual shift
mode, the DUONIC
TM
system will switch to the
automatic shift mode. When the DUONIC
TM
system switches to the automatic shift mode,
the multi-information display will show “ ”.
• Before pressing the ON side of the main switch
to set a desired speed, make sure the exhaust
brake switch is in the OFF position. You will not
be able to set the speed if the exhaust brake
switch is in the ON position. When driving with
the cruise control active, exhaust braking can be
used as usual, but the cruise control function will
be deactivated while exhaust braking is being
used.
3 To increase the set speed in cruise con-
trol mode
•
By using the SET/RESUME switch
Turn the SET/RESUME switch toward the
“RESUME” side. The vehicle will accelerate.
Release the switch when the desired speed is
reached. The vehicle will cruise at the new, higher
speed.
• By using both accelerator pedal and SET/
RESUME switch
1. Use the accelerator pedal to reach the desired
speed.
Z21525
Z21527
Z21524
FE_FG.book Page 39 Tuesday, February 8, 2011 4:00 PM
To Next Page
Loading...
Need help?
General
