10-21
3.4 Programming stations to preset buttons
• Manual programming
1. Select the desired band from FM1, FM2, AM1
and AM2 using the “AM/FM” button.
2. Make the frequency of your desired station
appear on the display by using the “ ” or “ ”
tuning button.
: Press this button for higher frequencies.
: Press this button for lower frequencies.
If you give the “ ” or “ ” button a long press
(more than 1 second) and then release it, the
radio starts automatic tuning after a short beep
and will then stay tuned to the first receivable
station.
NOTE:
Use manual tuning if you cannot tune to a desired
station by automatic tuning due to poor signal
reception.
3. Give the desired preset button a long press. A
short beep will sound indicating that the
selected station has been programmed to the
button.
NOTE:
• If you program a new station to a preset button
to which another station has previously been
programmed, the original station will be auto-
matically cancelled.
• If the battery is disconnected or the associated
fuse is removed, all stations programmed to pre-
set buttons are erased from memory and you
will need to program the stations again.
Z21762
Z21763
Z21077
FE_FG.book Page 21 Tuesday, February 8, 2011 4:00 PM
To Next Page
Loading...
Need help?
General
