10-32 Interior equipment and accessories
6.2 Activating the alarm
• Giving the “ALARM” button a long press acti-
vates (arms) the alarm; giving another long
press deactivates (disarm) the alarm. A short
beep sounds every time the alarm is activated or
deactivated.
If the alarm time is not yet set, the display auto-
matically changes to the alarm time setting
screen. You should then set the alarm time
according to the procedure described in the pre-
ceding paragraph.
• Alarm symbol appears when the alarm is
activated. It disappears when the alarm is deac-
tivated.
• The alarm buzzer sounds even during radio
reception or CD playback, the beep being
superimposed on the radio or CD sound.
• The alarm buzzer sounds at the preset time and
the beep lasts 3 minutes. To stop the beep, push
any button other than the power/volume knob. If
you push the power/volume knob, the alarm
stops and the radio turns on or off.
NOTE:
• You can activate or deactivate the alarm by giv-
ing the “ALARM” button a long press even when
the starter switch is in the “LOCK” or “ACC”
position.
• The set alarm time will be cleared if you do not
operate any radio/CD player control for one
week or you do not operate the vehicle (i.e. the
starter switch is not turned to the “ON” or “ACC”
position) for one week.
• The alarm is triggered regardless of the starter
switch position. We recommend deactivating the
alarm when not using it.
Z21100
FE_FG.book Page 32 Tuesday, February 8, 2011 4:00 PM
To Next Page
Loading...
Need help?
General
