Figure 113: Power Management Tab
On Face Down
The On Face Down section provides configurable options to control what happens when the MC32N0 is placed with
the display face down.
Select the Display Off checkbox to turn off the backlight when the MC32N0 is placed face-down. The backlight
automatically powers on when the MC32N0 is tuned face-up.
Select the Suspend checkbox to suspend the MC32N0 when it placed face-down. To wake the MC32N0 use the
controls listed in the Wake Up on Motion section below.
Keep Alive On Motion
Select the Enabled checkbox to prevent the MC32N0 from going into suspend mode while it is in motion. The
motion sensitivity is configurable. To set the sensitivity, tap the Change Sensitivity… button.
Note: Select the Enabled checkbox to prevent the MC32N0 from going into suspend mode while it is in
motion. The motion sensitivity is configurable. To set the sensitivity, tap the Change Sensitivity… button.
Wake Up on Motion
The Wake Up on Motion section provides configurable options for waking the MC32N0 from suspend mode by
shaking the MC32N0.
Select Inactivity checkbox to allow IST to wake the MC32N0 when it was suspended due to inactivity.
Use the Change Sensitivity… button to configure the sensitivity settings.
Setting Sensitivity
Use the slider to set the sensitivity. A low setting indicates that a harder shake (faster movement) is required for the
IST to initiate a wake up action. The sensitivity can be set from “0” to “10” and when the sensitivity is set to lower
values a simple shake/motion can be detected by IST. A high setting allows IST to issue a wake up action when an
easier movement to the MC32N0 is detected. Shake the MC32N0 to test the set sensitivity. An audio sound is heard
and a message is displayed on screen when the shaking level reaches the set sensitivity level.
136 | Settings for WinCE Devices
April 2015 | MN000887A01-B
To Next Page
Loading...
Need help?
General