Figure 82: MultiUser Login Screen
5 In the Login text box, enter the username.
6 In the Password text box, enter the password.
7 Touch OK.
Disabling the Multi-user Feature
Note: To disable the Multi-user Login feature, the user must have administrator rights. A message displays
at the bottom of the screen notifying the user.
Procedure:
1
Touch .
2
Touch .
3 Touch Disable MultiUser.
The Multi-user feature is disabled immediately.
Enabling Remote Authentication
Caution: When Remote Authentication is enable, the device searches for the remote server during the
login procedure. If the remote server is not available or the address is incorrect, the user would not be able
to login and an Enterprise reset is required to access the device.
Procedure:
1
Touch .
2
Touch .
3 Touch Load Server Info. The application reads the data from the server file and configures the Multi-user Login
feature.
4
Press
.
5 Touch Enable Remote Authentication.
The device accesses the remote server and then Login screen appears.
94 | Administrator Utilities
April 2015 | MN000887A01-B
To Next Page
Loading...
Need help?
General