3 - CONTROLS AND INSTRUMENTS
Power Take-Off gear lever (optional)
NOTICE: Operate the Power Take-Off (PTO) gear lever by correct “I” pattern. If operated diagonally, it may cause
a failure. If the PTO gear lever is not engaged smoothly, shift the lever again after lifting up the implement from the
ground to align the drive shaft.
The positions of the Power Take-Off (PTO) gear lever (1)
(optional) from the front of the tractor are: (A)
•
540 RPM
•
Neutral
•
750 RPM
•
1000 RPM
NHIL22CT00241AA 1
NOTICE: Before operating the PTO gear lever, depress
the clutch pedal (2) and place the PTO switch (3) in the
“OFF” position (4), this will stop the PTO shaft completely.
NHIL20CT00144AA 2
NHIL20CT00246AA 3
3-43
To Next Page
Loading...
Need help?
General
