7 - MAINTENANCE
Transmission uid level - Check
CAUTION
Burn hazard!
Do not handle any service uid (engine coolant, engine oil, hydraulic oil, etc.) at temperatures that
exceed 49 °C (120 °F). Allow uids to cool before proceeding.
Failure to comply could result in minor or moderate injury.
C0107B
NOTE: Check the transmission, rear axle, and hydraulic
system oil level after every 50 hours of operation.
1. With the engine off and the tractor standing level, check
the oil level using the dipstick (1).
NHIL16CT00450AA 1
2. The oil is at the correct level when it reads between
the two marks (A) on the dipstick. If the level is low,
add MULTIGRADE 134â„¢ (SAE 10W-30) hydraulic oil
through the dipstick hole. Do not îš¿ll above the dipstick
full mark.
3. Install the dipstick.
93100904 2
7-28
To Next Page
Loading...
Need help?
General
