3 - CONTROLS AND INSTRUMENTS
Seat belt - Roll Over Protective Structure (ROPS)
The retractable male end of the seat belt (1) is located on
left-hand side of the seat. To extend the length of the seat
belt, pull out on the male end until the correct length is
obtained. To latch the seat belt, insert the male end into
the buckle (2) located on the right-hand side of the seat.
Make sure that the seat belt buckle is secure, and that the
belt length is adequate for the operator to use.
Use soap and water to clean the seat belt if necessary.
Do not use carbon tetrachloride, naphtha, etc., as these
substances will weaken the webbing. Additionally, do not
bleach or dye the webbing, as these products will also
weaken the webbing.
NOTICE: You must replace damaged or worn seat belts.
NHIL22CT00233AA 1
3-6
To Next Page
Loading...
Need help?
General
