7 - MAINTENANCE
7 - MAINTENANCE###_7_###
General information
General information
Adequate lubrication and maintenance on a regular schedule is vital to maintaining your equipment. To ensure long
service and efîš¿cient operation, follow the lubrication and maintenance schedules outlined in this manual. The use of
proper fuels, oils, grease and îš¿lters, as well as keeping the systems clean, will also extend machine and component
life.
NOTICE: While any company can perform necessary maintenance or repairs on your equipment, NEW HOLLAND
strongly recommends that you use only authorized NEW HOLLAND dealers and products that meet the given speci-
îš¿cations. Improperly or incorrectly performed maintenance and repair voids the equipment warranty and may affect
service intervals.
NOTICE: Always use genuine NEW HOLLAND replacement parts, oils and îš¿lters to ensure proper operation, îš¿ltration
of engine and hydraulic systems. See your NEW HOLLAND dealer for additional oil quantities.
Regular lubrication is the best insurance against delays and repairs. Proper lubrication will extend machine life. Refer
to the following charts for lubricants and service intervals.
NOTICE: Failure to complete the required maintenance at the recommended intervals can cause unnecessary down-
time.
Use the intervals listed in the Lubrication Chart as guidelines when operating in normal conditions. Adjust the intervals
for operating in adverse environmental and working conditions. Shorten the intervals for sandy, dusty, and extremely
hot operating conditions.
WARNING
Avoid injury!
1. Disengage all drives.
2. Engage parking brake.
3. Lower all attachments to the ground, or raise and engage all safety locks.
4. Shut off engine.
5. Remove key from key switch.
6. Wait for all machine movement to stop.
Failure to comply could result in death or serious injury.
W1197A
WARNING
Illustrations in this manual may show protective shielding open or removed to better illustrate a par-
ticular feature or adjustment.
Replace all shields before operating the machine.
Failure to comply could result in death or serious injury.
W0012A
WARNING
Entanglement hazard!
Disengage the Power Take-Off (PTO), turn off the engine, and remove the key. Wait for all movement
to stop before you leave the operator's position. Never adjust, lubricate, clean, or remove a blockage
of crop material when the engine is on.
Failure to comply could result in death or serious injury.
W0227B
7-1
To Next Page
Loading...
Need help?
General
