4 - OPERATING INSTRUCTIONS
Stopping the unit
Stopping the engine
To stop the engine, carry out the following procedures:
1. Remain in the operator seat.
2. Pull the hand throttle lever rearward to the idle position.
NOTICE: After heavy work of the tractor, allow the engine to run at idle for approximately îš¿ve minutes to allow the
engine components to cool down.
3. Engage the park brake.
4. Ensure all gear shift levers, range levers or shuttle shift lever are in the neutral position and the Power Take Off
(PTO) switch is in the OFF position.
5. Push the Hydraulic Power Lift (HPL) control lever forward to lower implements to the ground.
6. Turn the key to the STOP position to shut the engine off.
NOTE: Turning the key to the STOP position and with the park brake NOT engaged, an alarm will sound. The alarm
will continue to sound for approximately ten seconds or until the park brake is engaged.
NOTE: If the key is not left in the STOP position after the engine has stopped, the warning lights will remain on and
discharge the battery.
4-38
To Next Page
Loading...
Need help?
General
